Siemens CL-110, Руководство пользователя

Страница: 94 / 129

If you choose Non Realtime VBR, you have
to type in the following data.
The range for Peak Cell Rate is from 1 to
1690.
The range for Sustainable Cell Rate is from
1 to 1689 and must be smaller than Peak Cell
Rate.
The range for Maximum Burst Size is from 1
to 100.
After click Next , you will see the web page
listed as the right. Choose the protocol that
you want. And click
Next again.
The WAN IP settings will differ slightly
according to the protocol that you choose.
This graphic is the one that you will get if
you choose to add a new interface of
PPPoA/PPPoE mode. You can check
Enable
NAT or Enable Qos for your necessity. And
you can set the MTU value in this page.
If you want to add a new interface of PPPoE
mode and choose PPPoE from the previous
web page, you will get a web page as the
graphic listed in right side.
Please refer to Quick Setup for more
information if you don’t know how to set the
configuration.
If you want to add a new interface of
Bridging mode and choose Bridging from
the previous web page, you will get a web
page as the graphic listed in right side.
Please refer to Quick Setup for more
information if you don’t know how to set the
configuration.