Siemens CCMS2010-IR, Руководство пользователя, Страница: 41 / 96

Camera settings
41
Siemens AB
Security Products 05.2014
Triggered Action (Multi-option)
The administrator can specify alarm actions that will take when the alarm is trig-
gered. All options are listed as follows.
 Enable Alarm Output
Select the item to enable alarm relay output.
 IR Cut Filter
Select the item and the IR cut filter (ICR) of the camera will be removed (on) or
blocked (off) when an alarm input is triggered.
Note: The IR Function (Refer to IR Function ) could not be set as <Auto> mode if
this triggered action is enabled.
 Send Message by FTP/E-mail
The administrator can select whether to send an alarm message by FTP and/or E-
mail when an alarm is triggered.
 Upload Image by FTP
Select this item and the administrator can assign a FTP site and configure various
parameters. When the alarm is triggered, event images will be uploaded to the ap-
pointed FTP site.
<Pre-trigger buffer> function allows users to check what happened to cause the
trigger. The <Pre-trigger buffer> frame rate could be pre-determined. On the other
hand, <Post-trigger buffer> is for users to upload certain amount of images after
the alarm input is triggered.
NOTE:
Normally the setting range of the <Pre-trigger buffer> is 1 to 20. However,
the setting range will change accordingly if the frame rate of MJPEG on the <Video
Frame Rate> setting page is 6 or smaller.
Check the box <Continue image upload> to upload the triggered images during
certain time or keep uploading until the trigger is off. Select <Upload for __ sec>
and enter the duration in the blank. The images of the duration will be uploaded to
FTP when the alarm input is triggered. The setting range is from 1 to 9999 sec-
onds. Select <Upload during the trigger active> to make the images keep being
uploaded to FTP during the trigger active until the alarm is released. Set the Image
frequency as the upload frame rate. The setting range is from 1 frame to 15 frames.
NOTE: Make sure FTP configuration has been completed. Refer to FTP for further
details.
 Upload Image by E-mail
Select this item and the administrator can assign an E-mail address and configure
various parameters. When the
alarm input is triggered, event images will be sent
to the appointed E-mail address.
<Pre-trigger buffer> function allows users to check what happened to cause the
trigger. The <Pre-trigger buffer> frame rate could be pre-determined. On the other
hand, <Post-trigger buffer> is for users to upload certain amount of images after
alarm input is triggered.
NOTE:
Normally the setting range of the <Pre-trigger buffer> is 1 to 20. However,
the setting range will change accordingly if the frame rate of MJPEG on the <Video
Frame Rate> setting page is 6 or smaller.