GAMMA
instabus
Technical Product-Information
August 2017
Control Module Box AP 118
5WG1 118-4AB01
Technical Manual
AP 118, page 4 / 6
Siemens AG
Infrastructure and Cities Sector, Building Technologies
Update: http://www.siemens.com/gamma
© Siemens AG 2017
Control Products and Systems
Subject to change without further notice.
P. O. Box 10 09 53, D-93009 Regensburg
2.4.2.11/4
Mounting of RS / RL modules
B1
RS module
B2
RL module
B3
Type label (with space for physical address of the
module)
B4
Mounting location for RS / RL module in AP 118
Control Module Box or AP 641 Room Control Box
B5
Bus connection module with bus connection pins
for bus terminal block, LED for indicating normal
operating mode (LED off) or addressing mode (LED
on), Learning button and contacts to RS module
B6
Insertion point for bus connection module of the RS
module
B7
Snap-in point for bus connection module of the RS
module
B8
Learning button for switching between normal
operating mode and addressing mode and for re-
ceiving the physical address
B9
LED for indicating normal operating mode (LED off)
or addressing mode (LED on); returns to normal op-
erating mode automatically after receiving the phys-
ical address
B10
Bus connection pins of the module for connection
of the bus terminal block in the respective mounting
location
B11
Insertion point for bus terminal
B12
Bus connection block for single core conductors
with 0,6...0,8 mm Ø
B13
Hinge joint for mounting hinge of the RL module
B14
Terminals
∂
Mounting of a RS module:
- AP 118: Remove the lid of the Control Module Box.
-Insert the bus connection module (B5) in such a way
into the insertion point (B6) for the bus connection
module that the bus connection pins (B10) point to the
insertion point for the bus terminal (B11).
- Press the bus connection module (B5) down until it
snaps into the locking position (B7).
-Insert the RS module (B1) from the top with the termi-
nals (B14) pointing away from the bus terminal inser-
tion point (B11). The type label (B3) is on top.
-Insert the bus terminal (B12) of the mounting location
(B4) onto the bus connection pins (B10) of the bus con-
nection module (B5).
-For assignment of the Physical Address press the learn-
ing button (B8) for a maximum of 2 seconds. The ad-
dressing mode is indicated when the LED is on (B9). It
returns to normal operating mode (LED Off) automati-
cally after receiving the physical address.
- Mount the lid again.
figure 5: mounting of a RS module
∂
Dismounting an RS module:
- AP 118: Remove the lid of the Control Module Box.
- Remove the wiring from the terminals (B14).
- Remove the bus terminal (B12).
- To remove the RS module (B1), insert a screw driver
between the module and the mounting location siding
and push it up to release it from the snap-in hooks. Do
this on both sides.
- Pull the RS module (B1) from the mounting location
(B4).
- If an RL module (B2) shall be inserted into the mounting
location, detach the bus connection module (B5) from
the snap-in point (B7), swivel it up and pull it out of the
insertion point (B6).
Mount the lid again.
