Siemens 1FW4, Руководство по эксплуатации

Страница: 93 / 116

A5E01083943A AB
Siemens AG Operating Instructions 2.02 1FW4
91
Replacement parts
8
8.1 Orders for spare parts
General
In addition to the exact part designation, please specify the motor type and the serial number
in all orders for spare parts. The part designation should be identical to the designation
stated in the list of spare parts and specified together with the appropriate part number.
Example: Bearing shield, drive end (part 5.00)
for type 1FW4 ..., no. ......
The type and serial number can be found in the specifications on the rating plate and the
technical data. In addition, they are also stamped on the end face of the shaft end on the
drive end.
When replacing rolling-contact bearings, in addition to the bearing identification code, the
replacement code for the bearing version is required. Both of these codes are specified on
the lubricant plate and in the motor documentation, or can also be taken from the installed
bearings.
NOTICE
Insulation of the bearing housing
After installing the bearing housing, the insulating capability of the bearing housing
insulation must be checked.
Commercially available, standard components can be used, but please ensure that the
construction type, dimensions, strength class, etc., are the same.
The graphical representations in this chapter show schematic diagrams of the basic
versions. They are used for spare parts definitions. The supplied version may differ in details
from these representations. [ID 1153.00]
8.2 Information on the anti-condensation heating
Installing the anti-condensation heating
The anti-condensation heating must only be installed by experts from the SIEMENS Service
Centers (refer to the note in the "Repair" section. [ID 81]