Setup
menu
Parallel
The parallel interface PAR can be set here.
Possible settings:
LPT1 (378h)
The parallel interface PAR is set to address 378h and IRQ7.
LPT3 (3BCh)
The parallel interface PAR is set to address 3BCh and IRQ7.
DISABLED
The parallel interface PAR is off.
Default entry:
LPT1 (378h)
Par Mode
You can define here whether the parallel interface PAR can only send, or
both send and receive.
Possible settings:
PRINTER
The parallel interface PAR can only send.
BIDIRECTION
Additional software enables the parallel interface PAR to send and
receive.
Default entry:
PRINTER
Diskette Write
This field allows you to define whether floppy disks can be written and
deleted. Possible entries:
ENABLED
Floppy disks can be read, written or deleted.
DISABLED
Floppy disks can be read only.
Default entry:
ENABLED
A26361-D756-Z120-1-7619
15
Setup menu
Diskette CTRLR
This field allows you to disable the diskette controller on the system board.
Possible entries:
ENABLED
The diskette controller on the system board is on.
DISABLED
The diskette controller on the system board is off.
Default entry:
ENABLED
Hard Disk CTRLR
This field allows you to disable the hard disk controller on the system board.
Possible entries:
ENABLED
The IDE hard disk controller on the system board is on.
DISABLED
The IDE hard disk controller on the system board is off.
Default entry:
ENABLED
HD Ctrl Mode
With this input field, you can set the transmission speed of the IDE hard disk.
If the integral IDE hard disk drive does not support this function, select the
STANDARD
entry.
Possible entries:
STANDARD
Normal transmission speed.
IDE HIGH SPEED
High transmission speed.
This setting is supported by most hard disks with a disk buffer of four
KBytes or more.
Default entry:
STANDARD
16
A26361-D756-Z120-1-7619