03.2021
8/20
H47.FENS083EN-02
AERO
Original operating instructions
AEROMAT VT RS2
6.4
Installation sequence
1.
Remove.the.
AEROMAT VT RS2
.carefully.from.the.
packaging.and.do.not.place.it.on.the.weather.grille.
or.front.panel..We.recommend.storing.the.unit.
on.a.soft.surface.(e.g..cardboard.or.sheet).during.
installation.
2.
Close.the.sliders.on.the.front.to.prevent.dirt.(e.g..
dust).from.entering.the.unit.during.installation..If.
the.
AEROMAT VT RS2
.does.not.have.sliders,.tape.up.
the.recesses.in.the.front.panel.with.film.
3.
Make.sure.that.no.dirt.and.liquids.can.get.inside.
AEROMAT.VT.RS2.including.the.weather.grille.prior.
to.the.installation.of.the.exterior.insulation.or.
cladding.
According.to.the.installation.location,.it.is.
therefore.necessary.to.adhere.the.
AEROMAT VT RS2
at.points.where.rain.could.permeate.
AEROMAT VT
Film
Adhesive.tape
Exterior.insulation
Adhesive.tape
Example:."concealed.installation.in.the.wall
with.wall.duct"
AEROMAT VT
Exterior.insulation
Film
Adhesive.tape
Adhesive.tape
Example:."concealed.installation.in.the.lintel"
4.
Install.the.
AEROMAT VT RS2 in its intended
installation.position.and.seal.it.in.accordance.with.
the.installation.directives.applicable.on.site.
5.
Check.
AEROMAT VT RS2
.for.cleanliness.prior.to.
starting.it.up..Clean.if.necessary.(see."maintenance.
and.care".on.page.
12).
Only.drill.in.through-holes.for.wall.plugs.and.
screws.in.the.area.indicated.(see.marker.tape).
Remove.any.marker.tape.that.is.visible.after.
installation.
