22
Default Configuration Parameters
The configuration parameters can be loaded with
predetermined default values. These are the settings
loaded into the instrument prior to shipment from the
factory. To load the default values proceed as follows:
a) Open switch V2 (see Figure 1, Configuration
Procedure).
b) The upper display will show:
3 digit dual display
3 digit deviation bar
3 digit heat/cool
c) Press the
▼
key; the lower display will show the
firmware version.
d) Still holding the
▼
key, press the
▲
key. The display
will show:
e) Within 10 seconds, press the
▲
key. The display will
show:
f) Press the
▲
or
▼
key to select the desired default
parameters (see table on following page).
g) Press the FUNC key; the display will show:
This indicates that the loading procedure has been
initiated. After about 3 seconds the loading procedure is
complete and the instrument reverts to the display shown
in step b. The following is a list of the default configuration
parameters loaded during the procedure:
Содержание Barber Colman 7SD
Страница 1: ...1 Instruction Manual 1262 IN 001 0 03 July 1998 D Models 7SD 7SH 7SM Controllers...
Страница 30: ...30 Notes...
Страница 31: ...31 Notes...
