SIDESHIFT INSTALLATION GUIDE
V1.7
18
NOTE:
The joystick and wireless key fob are preprogrammed for operation.
No pairing or programming is required.
OPERATING THE THRUSTER
WARNING
: The thruster is equipped with an overload protection circuit. Should
the thruster encounter an obstruction when being retracted or
deployed, the unit will shut down a continuous alarm will sound.
You must turn power off and then power back on to the joystick,
which will reset the unit. Clear any obstruction under the boat and
proceed normally.
WARNING
: Deploy and operate the thruster only when the boat is at slow speed
or stopped. Never deploy the thruster when the boat is at speed as
this may enable the overload protection circuit(see above warning)
or damage the unit.
WARNING
: Ensure the area under the boat is clear when operating the thruster
and that there are no swimmers in the area.
1.
Turn power on to the joystick by holding the power button for 1 second.
A beep will sound and the blue joystick light will activate.
2.
To lower the thruster, press and release the down button on the joystick
console. A fast beep will sound during deployment, and a slow beep will
sound once the thruster is in the fully down position and ready for use.
3.
Use the thruster in short bursts as required. Do not run for more than
20-30 seconds at a time.
4.
To retract the thruster push the up button on the joystick console. A fast
beep will sound. When the unit is fully retracted the joystick will
automatically power off.
5.
The joystick will automatically power-off after 5 minutes of non-use.
