SIDESHIFT INSTALLATION GUIDE
V1.7
17
7.
Plug the power cable into the back of the joystick
8.
Run a thin bead of marine sealant in the groove around the underside
perimeter of the joystick, insert into the 2 ½” cutout and press in place.
Use a sharp knife or razor to trim any excess sealant.
CONNECTING WIRELESS JOYSTICK
AND ACTUATOR CONTROLS
Refer to PT230 schematic on page 11 for complete system layout
1.
Position the control module in a dry location near the motor control box.
2.
Connect the red and black leads from the 4 pin motor control cable to
“battery neg” and “battery pos” on the battery.
3.
Connect “battery neg” and “battery pos” on the battery to “battery neg”
and “battery pos” on the motor control box.
4.
Connect the blue and green leads from the 4 pin motor control cable to
“switch 1” and “switch 2” on the motor control box.
5.
Plug the motor control cable into the black control module.
6.
Plug the 6 pin actuator cable into the black control module.
