3
SX80/185T & SX100/185T External sternthruster assembly
1.
1
- 20
10
Prior to installation, it is important that the installer reads this guide to ensure necessary acquaintance with this product.
The external sternthruster assembly must be handled carefully. Do not lift it by the cable connections.
Beware to keep installation within adviced measurements.
We advice to paint the gearhouse and propellers with antifouling. PS! Do not paint the zinc anodes, sealings or propellershafts.
Do not finish the inside of the tunnel with a layer of gelcoat / topcoat or similiar. It is only room for a thin layer of primer and two layers
of anti-fouling between the tunnel and the props.
With the boat on land, only run the thruster for a fraction of a second, as without resistance it will accelerate very fast to a damaging
rpm. Also, while the thruster is in air, make sure that the propellers have come to a complete stop before performing a direction
change of the thruster, as it does cause damage to the thruster.
This manual is intended to support educated / experienced staff and is therefore not sufficient in all details for the correct installation.
The external sternthruster assembly has been tested to be fully ignition protected so that it can be installed in an area with the
possibility of explosive gases in accordance to ISO 8846.
Do not install the thruster in a position where you need to cut a stiffener/stringer/support for the hull integrity without checking with the
boatbuilder that this can be safely done.
When installed in boats approved or classified according to international or special national rules, the installer is responsible for
following the demands in accordance with these regulations / classification rules. The instructions in this guide can not be guaranteed
to comply with all different regulations / classification rules.
NB ! Faulty installation of the tunnel, thruster or panel will render all warranty given by Sleipner Motor AS void.
Planning and important precautions
To achieve maximum effect, reliability and durability from your Sidepower stern thruster, a correct installation is very important.
Please follow the instructions carefully, and make sure that all checkpoints are carefully controlled.
Additional considerations for positioning of the stern thruster
Make sure that the external sternthruster assembly does not disturb the waterflow under the hull
Ensure that when installed the thruster does not foul exisiting equipment inside the boat like motor bedding etc.
Make sure that the water flow from the thruster are not intereferred to much by sterndrives, trimtabs etc. as this will reduce the thrust
considerably. With sterndrives , we recommend the use of our additional cowls.
Stern thruster installation considerations
Do not remove the label stating serial number from the cables!
This serial number is required to get the
correct spare and service parts!
IMPORTANT!
