7
SE120/215T Ignition Protected thruster assembly
version 1.6 2015
1. Turn the propeller shaft so that the drivepin (5) is in a horizontal position and ensure that it is centred in the propellershaft.
2. Push the propellers onto the shaft with the track for the drivepin in an horizontal position (same direction as you set the drivepin), all
the way in. There should be almost no gap between the propeller hub and the gearhouse.
3. Place the washer (4) on the prop.shaft and then tighten the lock-nut (3) on the propeller shaft.
4. Place the anode (2) in its designated position and tighten the anode holding screw (1). Apply a thread glue (Loctite or similar) to
ensure that the anode holding screw does not un-screw itself from the propellers rotation.
Parts description:
1 : Screw for anode
2 : Anode
3 : Propeller lock nut
4 : Washer
5 : Drivepin for propeller
Fitting propellers
5
3
2
1
4
Locktite
