W I 1 8 0 C - P B | P R O F I B U S C O U P L E R
8018416.YM10/COMAT/ 2015-03-13 | S I C K A G
Subject to change without notice
1 5
6
COMMISSIONING
6
Commissioning
6.1
Configuration
1. Adjust the PROFIBUS address provided on the two address switches on the front of
the WI180C-PB. Use a small screwdriver to do this.
Note:
The address can be in the range between 01 and 99.
The upper rotary switch "×10" represents a multiple of 10. The lower rotary switch "xy"
represents a value between 0 and 9.
The WI180C-PB must be restarted after every change of address by switching off and
on again, before the new address is transferred.
2.
Call up your PLC/PROFIBUS development or configuration environment.
3.
Download the current device file "Sick0E99.GSD" from
www.sick.com
.
4.
Install the device file "Sick0E99.GSD" in your project planning software.
6.2
Switching on
1. Switch on the power supply for the WI180C-PB.
2. Wait approximately two seconds until the WI180C-PB indicates that it is ready
