4
Depending on the type of window start, quit the teach-in process by
■
Pressing the Set pushbutton when the progress bar is shown on the display
Or
■
Deactivating windowing via the trigger input line
Or
■
Sending the “Trigger window stop” (ISDU 2 – Value 227) system command to
the sensor.
12345
12345
12345
5
The teach-in process is now complete; the quality of the process (quality of teach)
is shown on the display. If the teach-in process was started via the “ET” input line,
the signal should now be reset to LOW.
6.4.2
Teach-in for background and print (background, within the trigger window, textured)
NOTE
–
The direction of movement during teach-in must match the processing direction in
RUN mode.
–
If the background changes compared with the reference pattern that was taught
in, the level of correspondence and therefore the quality of print is reduced.
1
Start the teach-in process either by
■
Selecting the menu item “tch” on the display and confirming with Set. The
sensor now displays “bck”
Or
■
Setting the input line “ET” to HIGH
Or
■
Sending the “Start Teach” (ISDU 2 – Value 71) system command to the sen‐
sor.
The sensor is now in teach-in mode and waits for the background to be
taught in. Now position the sensor in front of the background to be taught in.
2
Start to teach in the background window either by
■
Pressing the Set pushbutton when “bck” is shown on the display
Or
■
Activating windowing via the trigger input line
Or
■
Sending the “Trigger window start” (ISDU 2 – Value 226) system command to
the sensor.
OPERATION
6
8022051/2018-01-31 | SICK
O P E R A T I N G I N S T R U C T I O N S | PSS Prime
19
Subject to change without notice
