ELECTRICAL INSTALLATION
5
57
8011325/18IM/2020-07-02|SICK
Subject to change without notice
O P E R A T I N G I N S T R U C T I O N S | ICR880/890
5.3.2
Connecting the camera system to the controller unit's voltage supply
Requirements for the voltage supply
In order to operate, the camera system requires a supply voltage of DC 24 V ± 10%
(protective extra-low voltage in accordance with standard IEC 60364-4-41 (VDE 0100
(part 410)), as is supplied as standard by the power supply unit in the controller unit.
The wire cross-section for the voltage supply to the camera system must be at least
3 mm
2
. In order to ensure the short-circuit/overload protection of the incoming supply
cable, the cable must be protected according to the wire cross-sections used.
The following standards must be observed:
•
DIN VDE 0100 (part 430),
•
DIN VDE 0298 (part 4), or
•
DIN VDE 0981 (part 1).
Connecting the camera system to the controller unit's voltage supply
Fig. 40: Connecting the camera system to the controller unit's voltage supply
1. Make sure that the voltage supply for the controller unit is switched off.
2. Fold back the protective cap on the POWER IN connection on the camera and push the
Harting HanQ8 plug connector onto the male connector.
3. Connect the free cable end in the controller unit to the terminal strip for the supply
voltage (for terminal assignment, see chapter
5.3.9 Pin assignment of wire colors of
assembled cables with open end
The supply voltage remains switched off for further installation work.
Note
Note
