Sices DIPOT, Руководство пользователя

Страница: 12 / 17

12
User’s Manual
30016 30016 RESET - PWM reset value (0-8191) Read steps
corresponding
to RESET value
set with RESET
trimmer
30017 30017 RAMP - ramp value (0-32) (value
removed or added every 10 ms) Read steps
corresponding
to the ramp
value set with
RAMP trimmer
30019 30019 Test Flag (0 = normal mode, 1 =
test mode) (to enter the
test, short-
circuit pins 1 - 2
of JP107 on
start-up)
30020 30020 Mode (0 = DIPOT normal, 1 =
voltage isolator)
30021 30021 Modbus Address The modbus
address is
selected by
switches
30022 30022 Serial speed The baud rate is
selected by
switches
30023 30023 E2Prom test result When the board
is in test mode
and e2prom is
tested in this
register, the
result of the test
is: 0 = not
performed, 1 =
OK, 2 = Error)
30026 30026 Minimum value of 0-5V input in
points per voltage isolator
30027 30027 Maximum value of 0-5V input in
points per voltage isolator
30028 30028 Minimum value of 0-10V input in
points per voltage isolator
30029 30029 Maximum value of 0-10V input in
points per voltage isolator
30031 30032 0-5V INPUT - value calculated in
ohms
30033 30033
0-5V INPUT - Pressure calculated
30035 30036
0-5V INPUT - Value calculated in
Volts With 16
fractional bits
30037 30037 Pressure in kPa Example: value
of register 34 =
34*4 = 136 kPa
30041 30042 0-10V INPUT - value calculated in
ohms
30043 30043
0-10V INPUT - Temperature
calculated In tenths of a
degree (e.g.
305 = 30.5 °C)
30045 30046 0-10V INPUT - Value calculated in
Volts With 16
fractional bits
30051 30051 Current Loop Output: Current PWM
value