SICE S 65 E, Инструкция по эксплуатации

Страница: 110 / 352

110 Operator's Manual
S 65 E - S 65 E C
ancing weight will have to be applied in line with a spoke, proceed as follows:
- remain in the centred position;
- select the Divide side weight icon (displayed instead of the “select ALU pro-
grammes” icon);
- select the spoke dimension on the displayed window using the keypad: small, medium,
large or OFF (selection deactivated);
- confirm by pressing the enter button ;
- apply two new counterweights in the positions indicated.
The weight division operations can be performed on both balancing sides.
Static balancing
A wheel can be balanced using a single counterweight on one of its two sides or in the
centre of the well. in this case, the wheel is balanced
statically. However, there is still
the risk of dynamic unbalance, which becomes more significant as the width of the wheel
increases.
Proceed as follows to balance motorcycle or car wheels statically:
- Perform a spin.
- at the end of the spin, select the Balancing programmes icon and press
ENTER until the required programme is selected.
The displayed image now shows only one position search.
- Apply the balancing weight at 6 o'clock through the LASER line or at 12 o'clock (see
Chapter "Configuring Application Position Weights Stickers") on either the outer or in-
ner side, or at the centre of the rim well, indifferently. If applied in the well, the weight
is applied on a diameter smaller than the rated diameter of the rim. A value of 2 or 3
inches less than the rated value must therefore be entered when the diameter is set in
order to obtain correct results.
Best results can be achieved if the weight is divided into two parts to be applied on the
two sides of the rim.