SICE S 65 E, Инструкция по эксплуатации

Страница: 105 / 352

Operator's Manual
S 65 E - S 65 E C
105
sons;
To use this programme, proceed as follows:
1. Beforehand, select between one of the programmes, ALU 1P, ALU 2P by selecting the
ALU 1P Balancing programme or the ALU 2P Balancing programme icon.
The mask for measuring the unbalance on alloy rims is displayed.
2. Perform the wheel balancing with the procedure described in the “ALU 1P, ALU 2P
Programme" chapter, without however applying the outer weight.
3. Select the Hidden Weight icon. If the wheel is balanced on the outer side,
the machine displays the message shown in Fig. 22a on the screen.
22a
Figure 22a. Hidden Weights: procedure error
If there is an unbalance on the outer side (Pe) the machine will display the graphic that
indicates the selection of the P1 weight position.
Press at any time to exit the “hidden weights” programme.
4. To make work easier mark the position of the unbalance Pe on the tyre. To do this,
move the wheel to a centred position and make a chalk mark at 6 o'clock if the "LASER"
configuration is active, at 12 o'clock if the "H12" or "CLIP" configuration is active.
5. Turn the wheel to the position in which you wish to apply the first outer weight (P1)
and press to confirm.
To choose the exact position of weight P1 in relation to the unbalance Pe, use the 6
o'clock point as your reference if “LASER” configuration is active, or the 12 o'clock point
if the “H12” or “CLIP” configuration is active.
The angle between P1 and Pe must be less than 120°.
6. If the angle selected is greater than 120°, the machine displays Fig. 18a for approx.
3 seconds, to indicate that another position must be chosen. If instead the selected
angle is less than 120 °, the machine displays the graphic that indicates the selection of
the P2 weight position on the screen, allowing the user to continue with the next step.
7. Turn the wheel to the position in which you wish to apply the second outer weight (P2)
and press to confirm.