SIAM SUDOS-mini 2, Руководство по эксплуатации

Страница: 21 / 64

21
parameter (being changed) is displayed as a flashing sign.
This means that a parameter may be entered.

Navigation to the previous dimension through the
measurement database.

Turn on the tool.

Starts a fluid level measuring process.

Change any tool mode from back to the initial one by
consecutive pressing the LEVEL and MODE keys (move
back/ reset).

Turn the tool off by consecutively pressing the LEVEL and
INPUT/OUTPUT keys.

This special service key is used as a prefix key. It changes
direction
of the operation of the MODE and
INPUT/OUTPUT keys (only if the BACK key is pressed at
that moment). The BACK key significantly simplifies the
procedures of selection of a required digit when setting a
well and a well cluster number and other parameters, as well
as it makes it possible to correct a mistaken keystroke.
5.3.4. Operation modes of the tool
General notes

In this section the operation modes and their symbol display are
described. They are presented in the same order as they are initiated when
pressing the MODE key several times.

All parameters mentioned in this section (a number of well and well
cluster, test parameters) can be set in any order irrespective of each other
and they are stored in the tool's storage automatically (even if the tool is
turned off) until they are changed.
УРОВЕНЬ
ВОЗВРАТ