Press the Lock and Release Ring backwards
with your thumbs until you can access the
O-ring.
NOTE:
Do not use excessive force as
that might break the rings.
When Lock and Release Ring is trapped in its
backward position, you will be able to pinch
the O-ring and pick it out of its groove.
NOTE:
Do not use any sharp tools as they
may damage the O-ring
.
IMPORTANT:
• Lubricate the O-rings.
•
Avoid any lubricant on seals.
• Clean by disassemble and rinsing all
parts thoroughly in fresh water.
• Dry before assembly.
Lubrication
For best performance; lubricate the surface
marked with red. Use SI TECH Lube Stick.
• If high resistance occurs, disassemble and lubricate with SI TECH Lube Stick.
• If the rings are misaligned, disassemble and don again.
• Sand and debris caught up by lubricant on Glove Ring and/or Suit Ring may cause
leakage if not removed. Remove O-ring and make sure the O-ring groove and adjoining
surface on Suit Ring is clean before replacing the O-ring.
To change or to clean and lubricate the O-ring, follow these simple steps:
• After every dive you should check for damage or debris and clean the system with fresh water.
• Before every dive you may do the same check depending on how you store the system.
• The O-ring seal and its groove is especially important to check for dirt.
• Store the rings apart in a debris free enviroment.
