www.sitech.se
1a.1
Find appropriate Spanner Ring and move
it forward through the arm of the suit towards
the latex seal.
1a.3
Press the Suit Ring evenly onto the seal so that the seal tightens in between
the rings. Check for creases on the seal as creases may cause leakage.
1a.2
Position the Spanner Ring so that the
system does not affect your wrist movement
when diving.
1a.4
Test the strength of attachment by pulling
the arm of the suit and the Suit Ring in the
opposite direction. If the Suit Ring falls off,
change the Spanner Ring to a thicker one.
IMPORTANT:
Make sure that the soft rounded edge of the Spanner Ring heads forward so that the sharp edge
of the opposite side does not damage the seal.
The Quick Cuff system is a Modular Quick Change Solution for rapid change
of broken or torn seals. It was developed and launched years before the
Glove Lock QCP. The Glove Lock QCP however was designed so that the
user of Quick Cuff could benefit from it when choosing the Glove Lock QCP.
1b.1
Located on the inside of the Suit Ring of
the Glove Lock QCP, there is an edge that will
act as fixation point for the soft Wrist Ring of
the Quick Cuff System.
1b.2
Squeeze the soft Wrist Ring and insert it
into the Suit Ring of the Glove Lock QCP.
Expand the Wrist Ring fully and arrange so
that the edges of the rings come together.
1b.3
The last steps of the mounting process
is same as with a regular Quick Cuff System.
It only differs by the fact that you need to
choose the black Spanner Ring that comes
with the Glove Lock QCP kit instead of the
Spanner Ring delivered with the
Quick Cuff kit.
Always check for ceases, dirt
or damaged surfaces before mounting
and use of the equipment!
Spanner Ring, black
For illustrative reasons we are using a yellow Wrist Ring. (
This is not an available product!)
