38
IR Connector (J1)
If you have an Infrared device, this mainboard can implement IR transfer
function. To enable the IR transfer function, follow these steps:
Pin assignment:
Note:
Before connect your IR device, please be sure each IR on board pin
allocation is matchable with the pin of the IR device. Otherwise,
incorrect IR connection may do damage to your IR device.
Step 1.
Attach the 5-pin infrared device cable to J1 connector.
(Refer to the above diagram for IR pin assignment.)
Step 2.
Configure the Infrared transfer mode in field “UART 2 Mode” of
“Integrated Peripherals” sub-menu in BIOS setup program.
This mainboard supports HPSIR, ASKIR, and Standard transfer
modes.
E6
E4
E5
1
Wake-On-Modem Connector (JWOM1)
If you have a PCI modem card installed that supports wake-on-modem func-
tion, please connect the cable into the JWOM1 header on the mainboard. When
your system is in power-saving mode, any modem signal resumes system auto-
matically. And you also need to enable the item through “Power Management/
Wake Up Events” of BIOS setup program.
JWON1
JWOM1
