Codes
Description
8Fh
The hard disk controller has been reset. The floppy drive will be
con figured next.
9 1 h
Floppy configuration is complete. Hard disk configuration will be done
next.
94h
Hard disk configuration has complete. Setting the base and extended
memory sizes next.
96h
The memory size was adjusted because ofPS/2 mouse support and hard
disk type 47. Next performing any initialization required before passing
control to the adaptor ROM at C8000h.
97h
Initialization before C8000h adaptor ROM control has completed.
Checking the C8000h adaptor ROM, then passing control to it next.
98h
C8000h adaptor ROM has passed control back to WIN BIOS and
AMIBIOS POST. Doing any required processing after C8000h adaptor
ROM returns control next.
99h
The initialization required after the adaptor ROM test has completed.
Configuring the timer data area and printer base address.
9Ah
The timer and printer base addresses have been configured. Configuring
the RS-232 base 1/0 port address next.
9Bh
The RS-232 base UO port address has been configured. Performing any
initialization required before the coprocessor test next.
9Ch
The required initialization before the coprocessor test has completed.
Initializing the coprocessor next.
9Dh
The coprocessor has been initialized. Doing any required initialization
after the coprocessor test next.
9Eh
The required initialization after the coprocessor test has completed.
Checking the extended keyboard, keyboard 10, and Num Lock key next.
9Fh
The exteded keyboard check is done and the keyboard ID flag is set. The
Num Lock key has been turned On or Off as specified in WINBIOS and
AMIBIOS Setup. The keyboard 1D command will be issued next.
AOh
The keyboard ID command was issued. The keyboard ID flag will be
reset next.
A l h
The keyboard I D flag has been reset. The cache memory test will b e done
next
A2h
The cache memory test has completed. Displaying any soft errors next.
A3h
The soft errors have been displayed. Setting the keyboard typematic rate
next.
•
62 User's Manual
