- 39 -
3.3 System Memory Configuration
The FT62 mainboard has two 184-pin DIMM slots that allow you to install from
32MB up to 2GB of system memory. Each 184-pin DIMM (Dual In-line Memory
Module) Slot can accommodate 64MB, 128MB, 256MB, 512MB, and 1GB of
PC1600,PC2100, PC2700 or PC3200 compliant 2.5V single (1 Bank) or
double (2 Bank) side 64-bit wide data path DDR SDRAM modules.
Install Memory:
Install memory in any or all of the banks. The combination shown as follows.
Note: Maximum installed memory is 2GB.
Note : You do not need to set any jumper to configure memory since the
BIOS utility can detect the system memory automatically.
You can check the total system memory value in the BIOS Standard
CMOS Setup menu.
Upgrade Memory:
You can easily upgrade the system memory by inserting additional DDR SDRAM
modules in available DIMM slots. The total system memory is calculated by
simply adding up the memory in all DIMM slots. After upgrade, the new system
memory value will automatically be computed and displayed in the field " Stan-
dard CMOS Setup" of BIOS setup program.
Density
Device Width
Single/Double
184pin DDR DIMMs
64 Mbit
4M x 16
SS / DS
32 / 64 MB
8M x 8
SS / DS
64 / 128 MB
128 Mbit
4M x 32
SS / DS
32 / 64 MB
8M x 16
SS / DS
64 / 128 MB
16M x 8
SS / DS
128 / 256 MB
256 Mbit
8M x 32
SS / DS
64 / 128 MB
16M x 16
SS / DS
128 / 256 MB
32M x 8
SS / DS
256 / 512 MB
512 Mbit
32M x 16
SS / DS
256 / 512 MB
64M x 8
SS / DS
512 / 1024 MB
1024 Mbit
64M x 16
SS / DS
512 / 1024 MB
128M x 8
SS / DS
1024 / 2048 MB
