Shur-Co SHUR COVER, Руководство пользователя

Страница: 3 / 24

Thank you for buying this sheetinging system from Shur-Co
®
We ap-
preciate your confidence in our products. Please read and thoroughly
understand this manual before installing and/or operating this system.
Pay particular attention to important safety and operating instructions,
as well as warnings and cautions. The hazard symbol is used to
alert users to potentially hazardous conditions and is followed by cau -
tion, warning or danger messages.
Failure to READ AND FOLLOW INSTRUCTIONS could result in fail
-
ure of your system and/or personal injury. Your trailer requirements
may, however, call for minor variations to these instructions.
Please inspect your sheeting system periodically; repair or replace
worn or damaged parts.
QUESTIONS? CALL OUR HELP LINE:
+44 (0) 1795 473499
MON-FRI 8 AM-5 PM CENTRAL TIME
We at Shur-Co
®
are concerned with your safety and the safety of all
those operating this system. Therefore, we have provided safety de -
cals at various locations on your sheeting system. Keep decals as
clean as possible at all times. Replace any decal that has become
worn or damaged, painted over or otherwise difficult to read. Replace -
ment decals are available through Shur-Co
®
dealers.
SAFETY INSTRUCTIONS
To prevent rust, paint all exposed metal, such as weld seams and/or
metal exposed by grinding or cutting, with corrosion-resistant paint.
ShurCover Sheeting System
P/N 1127925 Rev. B
!
MESSAGE TO OWNERS
SAFETY
RUST PREVENTION
Hardware Identification/Box Preparation ..................................... 1
Sheet Installation ...................................................................... 2-3
Center Pole Drive Motor .............................................................. 4
Web Spool & Drive Motor ......................................................... 5-8
SMART3™ Wireless Receiver ............................................... 9-13
System Setup ....................................................................... 14-16
Replacement Parts ............................................................... 17-20
1. Aluminum Welder
2. #3 Phillips Insert Bit or #3 Phillips Screwdriver
3. Band Saw or Hack Saw
4. Torque Wrench
5. Socket Wrench
6. 17mm Socket
7. 17mm Combination Wrench
8. 8mm Socket or Nut Driver
9. 1/2" Socket
10. 19mm Socket
11. 19mm Combination Wrench
12. Tape Measure
13. Pencil
14. Electric Drill
15. 8mm Drill Bit (for 3/8" self-tapping screws)
16. 10mm Drill Bit (for 3/8" cap screws)
17. Air or Electric Wrench w/9/16” Socket
18. 9/16" Combination Wrench
19. 9/16" Socket
20. 5mm Drill Bit
21. 1/2" Combination Wrench
22. #2 Phillips Screw Driver
23. 3/8" Hex Driver
24. Wire Crimp Tool
25. 13mm Socket
26. 10mm Socket
Optional: Hot Knife, Spray Paint, Caulk or Rubber Sealant
TABLE OF CONTENTS
TOOLS REQUIRED
1. Always wear safety glasses during installation.
2. Keep body and clothing clear of moving parts.
3. Use only OSHA-approved ladders or scaf-
folding during installation process.
4. No other use of this system is authorized,
except as designed.
SAFETY INSTRUCTIONS