Shur-Co SHUR COVER, Руководство пользователя

Страница: 18 / 24

P/N 1127925 Rev. B
15
System Setup
- continued
STEP 7: Thread webbing through guides and secure webbing
to pull tube. Do not cut webbing to length at this time.
Connection may need to be adjusted but should be
secured to take full torque of motor.
webbing
web guide
blocks
these two web guides maybe be
positioned higher on trailer to
reduce wind whip during travel
STEP 8: Reconnect white quick-disconnect for center pole
motor. Quickly press and release Open button on
wireless receiver until hole in center pole motor is
lined up with hole in drive sprocket. Insert M10 x 45
cap screw
K
and secure with M10 nylon lock nut
U
.
STEP 6: Reconnect white quick-disconnect for spool motor
wire. P ress and hold close button. Allow webbing to
roll up on spool until 2430mm mark reaches bracket.
Two people may be needed to safely complete this
step.
STEP 4: Stretch webbing and mark 2540 mm from spool bracket.
STEP 5: Fasten spool bracket
cover to spool brack -
et with four M5 x 12
flanged screws.
WARNING
Use extreme caution working by spool. Keep
hands and fingers clear of all moving parts
and pinch points.
!
2540.0 mm
webbing
spool bracket
SECURE WEBBING TO PULL TUBE
step
1
step
2
step
3
step
4
K
U