SHOWTEC TECHNO DERBY V1, Руководство пользователя

Страница: 9 / 26

8
Ordercode: 43156
Techno Derby
Backside
Fig. 02
08) IEC power connector OUT
09) IEC power connector IN + Fuse T1A/250V
10) 3-pin DMX signal connector OUT
11) 3-pin DMX signal connector IN
12) LED d control buttons
13) Sound sensitivity control
14) Safety eye
15) Built-in microphone
16) Ground/earth connection
Installation
Remove all packing materials from the Techno Derby. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.