SHOWTEC TECHNO DERBY V1, Руководство пользователя

Страница: 10 / 26

9
Ordercode: 43156
Techno Derby
Control Modes
There are 4 modes:
Built-in programs (stand-alone)
Sound-controlled
Master/Slave
DMX-512 (1CH, 4CH)
One Techno Derby (Stand-alone)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Techno Derby is not connected with a DMX cable, it functions as a stand-alone device.
05) Please see page 14 for more information about the Built-in auto programs.
One Techno Derby (Sound-controlled)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Techno Derby is not connected with a DMX cable, it functions as a stand-alone device.
05) Please see page 14 for more information about the Sound-controlled mode.
Multiple Techno Derbys (Master/Slave Mode)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Use a 3-pin XLR cable to connect the Techno Derbys.
The pins: 01) Earth
02) Signal (-)
03) Signal (+)
05) Link the units as shown in Fig. 03, connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can
use the same functions on the master device as described on page 14 (Built-in or Sound-controlled).
This means that you can set your desired operation mode on the master device and all slave
devices will react the same as the master device.
Multiple Techno Derbys Master/Slave Set Up
Fig. 03