SHOWTEC Starzone Gobo Quake DMX, Руководство пользователя

Страница: 10 / 17

8
One Gobo Quake
1. Fasten the Gobo Quake onto firm trussing. Leave at least 1 meter on all sides for air circulation.
2. Plug one end of the electric mains power cord into the IEC socket on the unit .
Then plug the other end of the cord into a proper electric power supply socket.
3. Turn on the music. If MODE is set to Sond (Audio), then the fixture will react to the beat of the music.
Multiple Gobo Quakes
1. Fasten the effect light onto firm trussing . Leave at least 1 meter on all sides for air circulation.
2. Use a 3-p XLR cable to connect the Gobo Quake s and other devices.
The pins:
1. Earth
2. Signal -
3. Signal +
3. Link the units as shown in (figure 4), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
4. Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the other
end of the mains power cord into proper electric power supply sockets, starting with the first unit. Do
not supply power before the whole system is set up and connected properly.
Multiple Gobo Quakes Set Up
DMX-Set up
Master/Slave Set up
Fig. 4
Note : Link cables before connecting electric power