SHOWTEC STAGEBEAM MKII 2000W FRESNEL V1, Руководство пользователя

Страница: 12 / 16

11
Ordercode: 30730/30731
Stagebeam MKII 2000W Fresnel
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
No Light
If the light effect does not operate properly, refer servicing to a technician.
Suspect three potential problem areas as: the power supply, the lamp, the internal fuse.
01)
Power supply. Check if the unit is plugged into an appropriate power supply.
02) The lamp. Replace the lamp. See page 8 for installing the lamp.
03) The internal fuse. Return the device to your Showtec dealer.
04) If all appears to be O.K., plug the unit in again.
05) If you are unable to determine the cause of the problem, do not open the Stagebeam, as this may
damage the unit and the warranty will become void.
06) Return the device to your Showtec dealer.
Problem Probable cause(s) Solution
One or more
fixtures do not
function at all
No power to the fixture
• Check if power is switched on and
cables are plugged in
Internal fuse blown
• Return the device to your Showtec
dealer
No light or lamp
cuts out
intermittently
Fixture is too hot
• Allow the fixture to cool down
• Make sure air vents in control
panel and the front lens are not
blocked
• Turn up the air conditioning
Lamp is damaged
• Disconnect the fixture and
replace the lamp
The power supply settings do not
match local AC voltage and
frequency
• Disconnect fixture. Check settings
and correct if necessary