SHOWTEC Spider LED, Руководство пользователя

Страница: 10 / 20

8
Auto program
One Spider LED (Sound-control)
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Plug the end of the electric mains power cord into a proper electric power supply socket.
3. The dipswitces have no influence during the Sound controlled modus.
4. When the Spider LED is not connected by a DMX-cable, it functions as a stand-alone device
5. For sound control dipswitch #12 must be set to ON. The other dipswitches must be OFF.
Turn on the music, then the fixture will react to the beat of the music. You can also adjust the
Sensitivity, by using the sensitivity control.
Multiple Spider LEDs ( Master/Slave control )
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Plug the end of the electric mains power cord into a proper electric power supply socket.
3. Use a 3-p XLR cable to connect the Spider LED.
The pins: 1. Earth
2. Signal -
3. Signal +
4.
Link the units as shown in (Fig. 2), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can
use the same functions on the master device as described on page 7+8 (Auto Run or Music control).
This means on the master device you can set your desired operation Mode and all slave devices will
react the same as the master device.
Master Control : Use dipswitch #1-#12 to play your the desired
mode.
Slave Control : Dipswitch #1 should be ON
Multiple Spider LEDs (Master/Slave control)
Fig. 2