SHOWTEC Scanmaster 1, Руководство пользователя

Страница: 10 / 34

11 12
3 4
2. Operation Guide 2. Operation Guide
2.1 Program Enable
2.2 Programming Scenes
Program
MIDI/Rec
1. Enter Program mode.
2. Press the Fixture button to turn on its fader
control, which is indicated by the lit LED.
You may select several fixtures at a time
by tapping of these Fixture buttons, so you
can assign several fixtures at a time with this
unit.
3. Create a desired scene using the faders.
The DMX value is 0 when the fader is fully
down(bottom) and 255 when it is fully up(top).
4. If necessary , you may tap the Page Select
button to control the second set of 8 DMX
channels.
5. Once the scene is satisfactory, tap the MIDI/Rec
button to program this scene into memory.
7 8
Chase Scene Bank
Auto trigger
Music trigger
Blackout
Step
PROG
Step/time
GENERAL
Display Information
This unit allows you to program 12 fixtures of 16 DMX channels, 30 banks of 8
programmable scenes, 6 chases of 240 programmed scenes using 8 faders and
other function buttons. Up to 8 scenes can be programmed into a bank, and the
amount of 240 programmed scenes can be stored into a chase and the scenes
can be triggered by Music, Auto, Tap Sync, MIDI and Manual.
The Segment Display consists of 4 digits. The first digit shows the active chase
number(1-6), the second digit shows the active scene number(1-8), and the third
and forth digits show the active bank number(01-30).
During Auto mode, a highlight
indicates its selection.
in the lower right corner of the Segment Display next to
" Auto trigger"
During Music mode, a highlight in the upper right corner of the Segment Display next
to " Music trigger" indicates its selection.
During Blackout mode, a fast blinking light indicates its selection in the upper left corner
of the Segment Display next to " Blackout".
During Program mode, a fast blinking light indicates its selection in the lower left corner
of the Segment Display next to " PROG.".
When the power is turned on, this unit enters
Manual mode automatically.
Press the Program button for three seconds to
activate Program mode, a fast blinking light in
the Segment Display next to "PROG." indicates
its selection.
Scanner 1-12