SHOWTEC PIXEL BAR 12 MKII, Руководство пользователя

Страница: 12 / 32

11
Ordercode: 41304
Pixel Bar 12 MKII
Control Panel
A. LED Display
B. Mode button
C. Setup Button
D. Up Button
E. Down Button
Fig. 05
DMX Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the backside of the device allows you to assign the DMX fixture address, which is
the first channel from which the Pixel Bar will respond to the controller. Please note when you use the
controller, the unit has up to
36 channels. When using multiple Pixel Bars, make sure you set the DMX
addresses right. Therefore, the DMX address of the first Pixel Bar should be 1(d001) ; the DMX address of
the second Pixel Bar should be 1+36=37 (d037) ; the DMX address of the third Pixel Bar should be 37+36=73
(d073) , etc. Please, be sure that you do not have any overlapping channels in order to control each Pixel
Bar correctly. If two or more Pixel Bars are addressed similarly, they will work similarly.
Controlling:
After having addressed all Pixel Bars, you may now start operating these via your lighting controller.
Note: After switching on, the Pixel Bar will automatically detect whether DMX 512 data is received or not.
If not, the problem may be:
• The XLR cable from the controller is not connected with the input of the Pixel Bar.
• The controller is switched off or defective, the cable or connector is defective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 25 seconds
When no button is pressed for 25 seconds, the display will turn off (except in Slave or DMX mode). To light
up the display, you have to press the
Mode , Setup , Up or Down button. Once you have pressed the
button, the display will light up.