SHOWTEC PIXEL BAR 12 MKII, Руководство пользователя

Страница: 8 / 32

7
Ordercode: 41304
Pixel Bar 12 MKII
Backside
Fig. 02
03) IEC Power Out (max 10A)
04) DMX signal connector (IN) 3-pin
05) DMX signal connector (OUT) 3-pin
06) Menu B LED display
07) Adjustment mounting bracket for Truss mounting
08) IEC Power In + Fuse T2L / 250V
Installation
Remove all packing materials from the Pixel Bar 12 MKII.
Check that all foam and plastic padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Control Modes
There are 6 modes: Sound-control
Static control
Built-in Programs
Auto Run
Master/Slave
DMX512 (3CH, 4CH, 6CH, 7CH, 9CH, 12CH, 18CH or 36CH)
One Pixel Bar ( Sound-control )
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) When the Pixel Bar is not connected by a DMX-cable, it functions as a stand-alone device.
04) Turn on the music. If device is set to (Audio), then the fixture will react to the beat of the
music. Please see page 14 for more information about the Sound-control mode.
One Pixel Bar (Static control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) When the Pixel Bar is not connected by a DMX-cable, it functions as a stand-alone device.
04) If device is set to , then the fixture can be manually controlled.
05) Please see pages 14 and 15 for more information about the Static control mode.