SHOWTEC Performer 5000 LED, Руководство пользователя

Страница: 19 / 32

18
Ordercode: 33050
Performer 5000 LED
Main Menu Options
DMX-512 Mode
Run Mode
Zoom/Dimmer/Color settings
White color calibration
General settings
Motor reset
1. DMX-512 Mode
In this mode you can set the DMX address.
01)
While in the main menu, press the UP/DOWN buttons until the display shows .
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to set the desired DMX address. The adjustment range is between
.
2. Run Mode
In this mode you can set the device as a master or slave.
01)
While in the main menu, press the UP/DOWN buttons until the display shows .
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to toggle between the 2 options:
Master Mode (DMX-controlled)
Slave mode
04)
If the display shows , the Performer will become a master device and will utilize the DMX
protocol to determine its performance.
05) If the display shows , the Performer will become a slave device and will react the same as the
master device.
3. Zoom/Dimmer/Color settings
You can enter the Zoom/Dimmer/Color settings by pressing the ZOOM/DIMMER/WHITE controls (on the
control panel) twice. You can also gain access by following the instructions below.
01) While in the main menu, press the UP/DOWN buttons until the display shows .
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to toggle between the 3 options:
Zoom
Dimmer
Color temperature settings
04)
When the display shows , press the ENTER button to open the zoom settings.