SHOWTEC Marquees Uplighter RGB LED, Руководство по эксплуатации продукта

Страница: 10 / 12

8
Channel 6 – Built-in Programs
0-35 No function
36-71 Slow Fade IN to Full beam then Out
72-107 Full beam to slow Fade Out
108-143 Slow Fade IN to Full Beam to Slow Fade OUT
144-179 Continuous Flow of all colors from slow to fast
180-251 Color Switching
252-255 Sound-controlled
Note : from 36-143 the intensities only work if you also use CH1, CH2, CH3 .
From 36-251 CH5 controls the changing speed of the built-in programs.
Channel 7 – Dimmer
Maintenance
The operator has to make sure that safety-relating and machine-technical installations are to be
inspected by an expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
1. All screws used for installing the device or parts of the device have to be tightly connected and must
not be corroded.
2. There may not be any deformations on housings, fixations and installation spots.
3. The electric power supply cables must not show any damages or material fatigue.
The Showtec Marquees Uplighter RGB LED requires almost no maintenance. However, you should keep
the unit clean.
Otherwise, the fixture’s light-output will be significantly reduced. Disconnect the mains power supply, and
then wipe the cover with a damp cloth. Do not immerse in liquid. Wipe lens clean with glass cleaner and
a soft cloth. Do not use alcohol or solvents. Keep connections clean. Disconnect electric power, and
then wipe the DMX and audio connections with a damp cloth. Make sure connections are thoroughly
dry before linking equipment or supplying electric power.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
1. If the device does not operate properly, unplug the device.
2. Check the power from the wall, all cables etc.
3. If all of the above appears to be O.K., plug the unit in again.
4. If you are unable to determine the cause of the problem, do not open the Marquees Uplighter RGB
LED,
as this may damage the unit and the warranty will become void.
5. Return the device to your Showtec dealer.
No Light
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
If the light effect does not operate properly, refer servicing to a technician.
Response: Suspect two potential problem areas: the power supply or the LEDs.
1. Power supply. Check that the unit is plugged into an appropriate power supply.
2. The LEDs. Return the Marquees Uplighter RGB LED to your Showtec dealer.
0-255 Dimmer, from closed to open (0-100%)