8
All LEDs ON
:
Dipswitch #6 and #10
Strobe Speed
: Dipswitch #1(Fast) and #2(Slow)
Automatic Mode
:
Dipswitch #8 and #10
Dipswitch #1 and #2 have no function.
One LED Roto Flower (
Sound control
)
1.
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
When the LED Roto Flower is not connected by a DMX-cable, it functions as a stand-alone device.
Dipswitch #10 must always be set to ON for manual control.
The LED Roto Flower will automatically change its color to the beat of the music. With the Audio
sensitivity control you can adjust its music-sensitivity.
Music Control
:
Dipswitch #7 and #10
Multiple LED Roto Flowers (
Master/Slave control)
1.
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Use a 3-p XLR cable to connect the DJ LED Flower.
The pins:
1.
Earth
2.
Signal -
3.
Signal +
3.
Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out"
socket to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
4.
Set DMX dip switches as follows
Master Control
:
Dipswitch #9 and #10
Slave Control
:
All Dipswitches should be OFF
You can use the same functions on the master device as described on page 7+8 (Built-in
Programs 1-7,
All LEDs ON, Automatic and
Music control)
This means on the master device you can use Dipswitch #3, #4, #5, #6, #7 and #8 depending on
your desired operation Mode and all slave devices will react the same as the master device.
Multiple LED Roto Flowers (
Master/Slave control)
Fig. 3
