SHOWTEC LED Imagespot 75W, Руководство пользователя

Страница: 12 / 24

11
Ordercode: 40713
LED Imagespot 75W
The LED Imagespot 75W can be operated with a controller in DMX mode or without the controller in
stand-alone mode.
Control Panel
A) LED display
B) MENU button
C) UP button
D) DOWN button
E) ENTER button
Fig. 03
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address, next time.)
DMX Addressing
The control panel on the upper side of the device allows you to assign DMX fixture addresses, which is the
first channel with which the LED Imagespot 75W will respond to the controller.
Please note, when you use the controller, the unit has
4 channels.
When using multiple LED Imagespots 75W, make sure you set the DMX addresses right.
Therefore, the DMX address of the first LED Imagespot 75W should be
1(001) ; the DMX address of the
second LED Imagespot 75W should be 1+4=5 (05) ; the DMX address of the third LED Imagespot 75W
should be 5+4=9 (009) , etc. Please, be sure that you do not have any overlapping channels in order to
control each LED Imagespot 75W correctly. If two or more LED Imagespots 75W are addressed similarly,
they will work similarly.
Controlling:
After having addressed all LED Imagespot 75W fixtures, you may now start operating these via your
lighting controller.
Note: After switching on, the LED Imagespot 75W will automatically detect whether DMX 512 data is
received or not. If not, the problem may be:
• The XLR cable from the controller is not connected with the input of the LED Imagespot 75W.
• The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 30 seconds
When no button is pressed for 30 seconds, the display will turn off.
To light up the display, you have to press the
MENU , ENTER , UP or DOWN button.
Once you have pressed the button, the display will light up.