12
Auto / Music /Manual Mode
Auto
1)
Press the Mode button (
19
) until the LED in front of Auto lights up green.
2)
You can control the Speed and Fade Time by adjusting the Speed and Fade Time fader (
23
+
24
).
Music
1)
Press the Mode button (
19
) until the LED in front of Music lights up green.
2)
You can control the Audio sensitivity by adjusting the Audio fader (
22
).
Fade Time is available in Music Mode
Manual
1)
Press the Mode button (
19
) until the LED in front of Manual lights up green.
2)
With Tap Sync you can manually go through the chase steps.
Fade Time (
16
) is available in Manual Mode
The LED Commander can be used as a plug-and-play device with the following Showtec products:
42431 Par 64 Short, RGB LED
42432 Par 64 Short, RGB LED
42421 Par 56 Short, RGB LED
42422 Par 56 Short, RGB LED
42400 LED Pinspot
42401 LED Pinspot
42410 Par 36 Short, RGB LED
42411 Par 36 Short, RGB LED
42460
LED RGB Par 64 High Power 18 x 3W
42461 LED RGB Par 64 High Power 18 x 3W
42435 LED Par 64, 24 x 1W
42436 LED Par 64, 24 x 1W
Maintenance
The
Showtec LED Commander re
quires almost no maintenance. However, you should keep the unit
clean. Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse
in liquid. Do not use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the DMX and audio connections
with a damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying
electric power.
Troubleshooting
Showtec LED Commander
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
1.
Fixture does not respond to controller: Check the DMX-address of the fixture and the controller.
Make sure they match. Make sure the connections are correct.
2.
Interference between chases; If the same channel is assigned to different running chases, the one
with the highest channel value will be put out.
3.
If the device does not operate properly, unplug the device.
4.
Check power from the wall, all cables, the settings, etc.
5.
If all of the above appears to be O.K., plug the unit in again.
6.
If nothing happens after 30 seconds, unplug the device.
Содержание LED Commander
Страница 1: ...LED Commander ORDERCODE 50717...
Страница 16: ......
