SHOWTEC ImageSpot 300, Руководство пользователя

Страница: 10 / 13

8
Replacing a Gobo
1. Disconnect mains power supply and set the switch to OFF.
2. Make sure that the gobo you want to insert has the same size.
Gobo diameter (metal or glass) 65 mm
Maximum image diameter 36 mm
Fig. 4
Troubleshooting
No Light
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
If the light effect does not operate properly, refer servicing to a technician.
Response: Suspect three potential problem areas: the power supply, the lamp, the fuse.
1. Power supply. Check that the unit is plugged into an appropriate power supply.
2. The lamp. Replace the old lamp with a new one with the same specifications. See page 5 for replacing
lamps.
3. The fuse. Replace the fuse. See page 7 for replacing the fuse.