SHOWTEC Explorer 575 Wash MKII, Руководство пользователя

Страница: 11 / 27

9
Installation
Installing the Lamp
The Showtec Explorer 575 uses the MSR 575 (ordercode 80915P / 80915O) bulb as manufactured by all
popular manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage ! Lamps with a higher wattage generate temperatures the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
Procedure :
1. Loosen the 3 screws ( X, Y, Z) on the backside of the lamp cover. See Fig. 4
2. Gently pull out the lamp board.
3. Read lamp instructions. Do not touch the lamp bulb glass. (See Fig 3.)
Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe off the glass with a clean, lint-free
towel and rubbing alcohol.).
4. Insert the lamp pins into the small holes in the lamp socket. You can adjust the distance between the
lamp and the lens (screw A) on the back.
5. Put the lamp board back and fasten the screws snugly.
Lamp board Lamp holder
1 2 3 4
Fig. 3
Backside Lamp Board
Fig. 4