SHOWTEC EventMOVE 4/4, Руководство пользователя

Страница: 10 / 24

Ordercode: 44020
EventMOVE 4/4
Control Modes
There are 5 modes: • Auto
• Manual
• Sound-controlled
• Master/Slave
• DMX-512 (6CH, 8CH, 13CH)
One EventMOVE (Auto and Manual)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the EventMOVE is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 15-16 for more information about Auto mode and Manual mode.
One EventMOVE (Sound-controlled)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Turn on the music. If the device is set to sound-control, then the EventMOVE will react to the beat of
the music. Please see page 15 for more information about the sound-control options.
Multiple EventMOVEs (Master/Slave control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin XLR cable to connect the EventMOVE.
The pins: 01) Earth
02) Signal -
03) Signal +
03) Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 15-16 (Auto, Manual
or Sound-controlled mode). This means that you can set your desired operation mode on the
master device and all slave devices will react the same as the master device.
Multiple EventMOVEs (Master/Slave control)
Fig. 03
9