SHOWTEC EventLITE 7/4, Руководство пользователя

Страница: 16 / 32

15
Ordercode: 44005
EventLITE 7/4
Control Panel
A).LED display
B). Mode button
C).Setup Button
D). Up Button
E). Down Button
Fig.08
DMX Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address, next time.)
DMX Addressing
The control panel on the back side of the device allows you to assign the DMX fixture address, which is
the first channel from which the EventLITE will respond to the controller. Please note when you use the
controller, the unit has up to
11 channels.
When using multiple EventLITEs, make sure you set the DMX addresses right. Therefore, the DMX address of
the first EventLITE should be
1(d001) ; the DMX address of the second EventLITE should be 1+11=12 (d012) ;
the DMX address of the third EventLITE should be 12+11=23 (d023) , etc. Please, be sure that you don’t
have any overlapping channels in order to control each EventLITE correctly. If two or more EventLITEs are
addressed similarly, they will work similarly.
Controlling: After having addressed all EventLITEs, you may now start operating these via your lighting
controller.
Note: After switching on, the EventLITE will automatically detect whether DMX 512 data is received or not.
If there is no data received at the DMX-input, the “ point “ behind the first digit will dim.
The problem may be:
• The XLR cable from the controller is not connected with the input of the EventLITE.
• The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Lock mode after 30 seconds
Display board will blackout and show if there is no operation within 30s. Press and hold down the
Mode and DOWN button simultaneously for 3s at least to unlock the display board.