SHOWTEC EVENTLITE 6/3, Руководство пользователя

Страница: 24 / 28

23
Ordercode: 44000
EventLITE 6/3 WDMX
Maintenance
The EventLITE 6/3 WDMX requires almost no maintenance. However, you should keep the unit clean.
Otherwise, the fixture’s light-output will be significantly reduced. Switch off the device and then wipe the
cover with a damp cloth. Wipe the front glass panel clean with glass cleaner and a soft cloth. Do not use
alcohol or solvents. The front glass panel will require weekly cleaning, as smoke-fluid tends to build up
residues, reducing the light-output very quickly.
Do not immerse in liquid.
Keep connections clean. Disconnect electric power, and then wipe the DMX connections with a damp
cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric power.
Troubleshooting
No Light
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, follow the steps below in sequence until a solution is found. Once the unit operates
properly, do not carry out the following steps.
If the light effect does not operate properly, refer servicing to a technician.
Response: Suspect two potential problem areas: the battery and the LED.
01)
Battery. Check if the battery is fully charged.
02) The LEDs. Return the EventLITE 6/3 WDMX to your Showtec dealer.
03) If all of the above appears to be in order, switch the unit on again.
04) If you are unable to determine the cause of the problem, do not open the EventLITE 6/3 WDMX, as
this may damage the unit and the warranty will become void.
05) Return the device to your Showtec dealer.
Temperature Control Protection
01) When the temperature of the LED board reaches 60°C or if the thermistor check fails, the
temperature protection will kick in and reduce the power output automatically.
Thermistor test failure: The thermistor is damaged, the Thermistor connection is faulty or the
microcomputer port is damaged.
02) Temperature control (LED signal) when the EventLITE 6/3 WDMX is powered on:
When the device is powered on, the device will check the temperature working condition.
When the Thermistor test fails, the red LED will light up.
When the Thermistor is working normally, the red LED will be off.
03) Temperature check via LCD display
Press the
MODE button and then turn on the EventLITE 6/3 WDMX.
If the temperature control is working, the display will show Check-up Tr1: xx
（
xx is the current LED
board temperature value.
If the temperature control is faulty, the display will show
Check-up Tr1: Er .
During this process, the brightness of a faulty device is far below that of a normal device.
Always check the temperature before using the EventLITE 6/3 WDMX.
No Response to DMX
Response: Suspect the DMX cable or connectors, a controller malfunction, a light effect DMX card
malfunction.
01)
Check the DMX setting. Make sure that DMX addresses are correct.
02) Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical power.
Try your DMX control again.
03) Determine whether the controller or light effect is to blame. Does the controller operate properly with
other DMX products? If not, take the controller in for repair. If it does, take the DMX cable and the
light effect to a qualified technician.