SHOWTEC Eventlite 177IR, Руководство пользователя

Страница: 15 / 28

14
Ordercode: 44010
EventLITE 177IR
Control Panel
A) LED display
B) MODE button
C) SETUP button
D) UP button
E) DOWN button
Fig. 05
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address, next time.)
DMX Addressing
The control panel on the backside of the device allows you to assign DMX fixture addresses, which is the
first channel with which the EventLITE will respond to the controller.Please note, when you use the
controller, the unit has
5 channels.
When using multiple EventLITEs, make sure you set the DMX addresses right. Therefore, the DMX address
of the first EventLITE should be
1(d001) ; the DMX address of the second EventLITE should be 1+5=6 (d006 );
the DMX address of the third EventLITE should be 6+5=11 (d011) , etc. Please, be sure that you do not
have any overlapping channels in order to control each EventLITE correctly. If two or more EventLITEs are
addressed similarly, they will work similarly.
Controlling:
After having addressed all EventLITEs, you may now start operating these via your lighting controller.
Note: After switching on, the EventLITE will automatically detect whether DMX 512 data is received or
not. If there is no data received at the DMX-input, the “ LED “ on the control panel will not flash.
The problem may be:
• The XLR cable from the controller is not connected with the input of the EventLITE.
• The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note:
It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 25 seconds
When no button is pressed for 25 seconds, the display will turn off.
To light up the display, you have to press the MODE, SETUP, UP or DOWN button.
Once you have pressed the button, the display will light up.
Lock mode after 60 seconds
Display board will blackout and show if there is no operation within 60s. Press the MODE and
DOWN button simultaneously for 3s at least to unlock the display board.