SHOWTEC City Painter 575, Руководство пользователя

Страница: 12 / 22

10
Control Mode
There are 3 modes to operate the City Painter 575:
DMX 512 Mode
Master Mode
Slave Mode
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the City Painter will respond to the controller.
Please note when you use the controller, the unit has
8 channels.
When using multiple City Painters, make sure you set the DMX addresses right.
Therefore, the DMX address of the first City Painter should be
1(001) ; the DMX address of the second City
Painter should be 1+8=9 (009 ); the DMX address of the third City Painter should be 9+8=17 (017) , the DMX
address of the fourth City Painter should be 17+8=25 (025) , etc.
Unit No. Address Binary Dip Switch Setting
Unit 1 1
Unit 2 9
Unit 3 17
Unit 4 25
Please, be sure that you don’t have any overlapping channels in order to control each City Painter correctly.
If two or more City Painters are addressed similarly, they will work similarly.
For address settings, please refer to the instructions under ”DMX 512 Mode”.
Controlling:
After having addressed all City Painter fixtures, you may now start operating these via your lighting
controller.
Note: After switching on, set switch #11 and # 12 to OFF, the City Painter will work with DMX
512 data.
If the device doesn’t work with DMX, the problem may be:
- The XLR cable from the controller is not connected with the input of the City Painter.
- The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.