3
Never let the power-cord come into contact with other cables! Handle the power-cord and all
connections with the mains with particular caution!
Never remove warning or informative labels from the unit. The operator should regularly check.
The operator must make sure that the texts are always clearly visible, legible and remain.
If text and/or icons are missing, damaged or illegible on the FX Shot, they should be replaced.
Do not open the device and do not modify the device.
Never use anything to cover the ground contact.
Never look directly into the FX Shot.
Never leave any cables lying around.
Never replace parts yourselves.
Never remove or deactivate safety devices.
All required safety equipment must be in good condition and must be working properly.
Do not insert objects into air vents.
Do not switch the device on and off in short intervals, as this would reduce the device’s life.
Do not shake the device. Avoid brute force when installing or operating the device. The FX Shot
reacts very sensitive to movement.
Do not touch the FX Shot while working or if it is connected to the mains power. Even if the FX Shot
is not in operation, the electric cannons can still be filled and cause harm.
Do not place the FX Shot in the vicinity of a vibration source.
Never use the device during thunderstorms, unplug the device immediately.
Only use device indoor, avoid contact with water or other liquids.
Only operate the device after having familiarized with its functions.
Only use the FX Shot according to the instructions in this manual
Avoid flames and do not put close to flammable liquids or gases.
Always allow free air space of at least 50 cm around the unit for ventilation.
Always disconnect power from the mains, when device is not used or before cleaning! Only
handle the power-cord by the plug. Never pull out the plug by tugging the power-cord.
Always keep the workplace clean and provide adequate ambient lighting.
Make sure that the device is not exposed to extreme heat, moisture or dust.
Make sure that the available voltage is not higher than stated on the rear panel.
Make sure that the power-cord is never crimped or damaged. Check the device and the power-
cord from time to time.
If the external cable is damaged, it has to be replaced by a qualified technician.
If device is dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do
not switch it on immediately. The arising condensation water might damage your device. Leave
the device switched off until it has reached room temperature.
If your Showtec device fails to work properly, discontinue use immediately. Pack the unit securely
(preferably in the original packing material), and return it to your Showtec dealer for service.
For adult use only. FX Shot must be installed out of the reach of children. Never leave the unit
running unattended.
The FX Shot may only be used if there are no persons, animals or other objects in the direct “line of
fire” of the electric cannon within the output distance. The shooting direction is the direction, in
which the electric cannon of the FX Shot is pointing. The output distance is dependent on the
content and length of the electric cannons.
Showtec is not liable for the damages caused by faults on the FX Shot.
The user is responsible for correct positioning and operating of the FX Shot. The manufacturer will
not accept liability for unsafe situations, accidents, damages caused by:
- The misuse or incorrect installation of this device.
- Ignoring warnings or instructions as shown in this manual.
- Using the FX Shot for purposes or conditions other than specified in this manual.
- Changes to the FX Shot. This includes the use of other than original spare parts.
- Inadequate maintenance.
- The unauthorized removal of safety covers and / or guards.
- The improper use of the FX Shot.
This device falls under protection class I. Therefore it is essential to connect the yellow/green
conductor to earth.
Repairs, servicing and electric connection must be carried out by a qualified technician.
WARRANTY: Till one year after date of purchase.
Содержание 60908
Страница 16: ......
