SHOWTEC 51346, Руководство пользователя

Страница: 21 / 44

20
Galactic RGB-2000
Product code: 51346
DMX Linking
To connect multiple devices on one DMX data link, follow the steps below:
Use a 3-pin DMX cable to connect the DMX OUT connector of the lighting controller to the DMX IN
connector of the first device.
Connect the first device’s DMX OUT connector to the second device’s DMX IN connector with a
3-pin DMX cable.
Repeat step 2 to connect all devices in a daisy-chain as shown in Fig. 13.
Insert the included SD card into the SD slot (13) on each connected device.
Connect a DMX terminator (120 Ω resistor) to the DMX OUT connector of the last device on the data
link.
Fig. 13
DMX Addressing
In a setup with multiple devices, make sure that you set the DMX starting address of each device
correctly. The Galactic RGB-2000 has 2 personalities: 1 channel and 13 channels.
If you want to connect multiple devices on one data link, follow the steps below:
Set the starting address of the 1
st
device on the data link to 1 (001).
Set the starting address of the 2
nd
device on the data link to 14 (014), as 1 + 13 = 14.
Set the starting address of the 3
rd
device on the data link to 27 (027), as 14 + 13 = 27.
Continue assigning the starting addresses of the remaining devices by adding each time 13 to the
previous number.
Make sure that you do not have any overlapping channels in order to control each Galactic RGB-2000
correctly. If two or more devices are addressed similarly, they will work similarly.