SHOWTEC 50348, Руководство пользователя

Страница: 9 / 12

8
Ordercode: 50348
Multi Exchanger
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 110V specification product on 230V power, or vice versa.
01)
Flip the power switch (01) to ON position.
02) Press and hold down the MENU button (05) for 5 seconds to enter the mode settings.
03) Repeatedly press the MENU button (05) to toggle between the following operation modes:
Mode selection  Press the UP/DOWN buttons (04/06) to select DMX or MIDI. The corresponding
LED will blink.
 Press the MENU button (05) to confirm.
DMX mode  When the DMX LED blinks, the display will show the blinking DMX starting
address (A001–A512).
 Press the UP/DOWN buttons (04/06) to select the desired address.
 Press the MENU button (05) to confirm.
MIDI mode  When the MIDI LED blinks, the display will show the blinking channel number
(CH01–CH16).
 Press the UP/DOWN buttons (04/06) to select the desired channel.
 Press the MENU button (05) to confirm.
HOLD mode  When the display shows ON or OFF, the HOLD LED will be on.
 Press the UP/DOWN buttons (04/06) to select ON/OFF.
 If set to ON, the device will use the last active scene, in case of a DMX failure.
 If set to OFF, the last active scene will not be used.
Speed settings  When the display shows SP01-SP99, press the UP/DOWN buttons (04/06) to
select the desired chase speed.
 The adjustment range is between 01-99, from slow to fast.
Channel settings  When the display shows C-01–C-72, press the UP/DOWN buttons (04/06) to
select the desired channel.
 Press the MENU button (05) to confirm and leave the mode settings.
 If you select C-48, the channels 1-48 will be executed in a sequence.
04)
When the DMX LED is lit, the display shows the DMX starting address AXXX and the 72 channel DMX
signals, beginning from the AXXX, will be converted to 72 channel analog outputs. If a DMX signal is
present, the DMX LED will blink.
05) When the MIDI LED is lit, the display shows the MIDI channel number (CH01–CH16). The MIDI signals
from NOTE NO. 22-93 are converted to 72 channel analog outputs. When a MIDI signal is present, the
MIDI LED will blink.
06) When the device receives a DMX signal, after the setting of scenes has been finished, press and hold
down the
STORE button (08) for 5 seconds until the display shows GOOD. The scene will have been
saved. Release the STORE button (08) to return to DMX input.
07) Press the STORE button (08) to run a pre-stored scene. The display will shows STOR. In the mode
settings, this function is not available.
08) Press the CHASE button (07) to enter the CHASE mode. The display will show CHAS.
09) Choose one of the 3 analog output options: +(-) 10V, +(-) 12V or +(-) 15V.
 Make sure that the DIP switch # 1 is always set to ON.
 Set the DIP switch #2 to ON for 15V, DIP switch #3 for 12V or DIP switch #4 for 10V.
 Remember that any two of the DIP switches #2, 3 and 4 may not be set to ON at the same time.