19
Kanjo Scan 60
Product code: 45012
Control Panel
A)
LED display
B)
ENTER button
C)
UP button
D)
DOWN button
E)
MENU button
Fig. 12
●
Use the MENU button to exit the current submenu, to return to the main menu and to return to the
start screen.
●
Use the UP/DOWN buttons to navigate through the menus or to increase/decrease numeric values.
●
Use the ENTER button to open the desired menu, to confirm your choice or to set the currently
selected value.
Start-up
Upon start-up the display will show the following screen:
Immediately afterwards the display will show the start screen. The start screen provides information about
the current control mode of the device:
DMX control mode with DMX starting address 001
A blinking dot at the bottom right corner of the display indicates that
DMX signal is present. If the dot does not blink, the DMX signal is lost.
The device is a master device in master/slave setup and plays the
built-in program. See 6.6.4. Master/Slave Mode on page 22 for more
information.
Note:
If no button is pressed, after 50 seconds of inactivity the display will return to the start
screen and after 50 more seconds it will turn off. Press any button to turn the display on.
See 6.6.6. Display LEDs on page 23 for more information.
