SHOWTEC 40910, Руководство пользователя

Страница: 14 / 32

13
Ordercode: 40910
City Painter 9000 LED
Control Panel
A) LED display
B) MENU button
C) SET button
D) UP button
E) DOWN button
Fig. 04
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address, next time.)
DMX Addressing
The control panel on the base of the device allows you to assign DMX fixture addresses, which is the first
channel with which the City Painter will respond to the controller.
Please note, when you use the controller, the unit has
11 channels.
When using multiple City Painters, make sure you set the DMX addresses right.
Therefore, the DMX address of the first City Painter should be
1(001) ; the DMX address of the second City
Painter should be 1+11=12 (012 ); the DMX address of the third City Painter should be 12+11=23 (023) , etc.
Please, be sure that you do not have any overlapping channels in order to control each City Painter
correctly. If two or more City Painters are addressed similarly, they will work similarly.
Controlling:
After having addressed all City Painter fixtures, you may now start operating these via your lighting
controller.
Note: After switching on, the City Painter will automatically detect whether DMX 512 data is received or
not. If not, the problem may be:
• The XLR cable from the controller is not connected with the input of the City Painter.
• The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note:
It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.